Hurricane Shutters Services

NOA ALUMINUM ACCORDION SHUTTERS

 

 

 

 

 

NOA ALUMINUM ACCORDION SHUTTERS

MAMI DADE EPARTMENT OF REGULATORY AND ECONOMIC RESOURCES
BOARD AND CODE ADMINISTRA TION DIVISION

MIAMI-DADE COUNTY
PRODUCT CONTROL SECTION
11805 SW 26 Street, Room 208:
Miami, Florida33175~2474
T (786)315·2590 F (786~315·259~:
www.miamidade.gov/building

NOTICE OF ACCEPTANCE (NOA)
Calleja’s Accordion Shutters, Inc.
940 West 84th Street
Hialeah, Florida 33014
SCOPE:
This NOA is being issued under the applicable rules a~d regulations governing the use of construction materials.
The documentation submitted has been reviewed and ccepted by Miami-Dade County RER-Product Control
Section to be used in Miami Dade County and other a eas where allowed by the Authority Having Jurisdiction
(AHJ).
This NOA shall not be valid after the expiration d e stated below. The Miami-Dade County Product Control
Section (In Miami Dade County) and/or the AHJ (i areas other than Miami Dade County) reserve the right t6
have this product or material tested for quality assur nee purposes. If this product or material fails to perform in.
the accepted manner, the manufacturer will incur t e expense of such testing and the AHJ may immediately
revoke, modify, or suspend the use of such product 0 material within their jurisdiction. RER reserves the right to
revoke this acceptance, if it is determined by Miam -Dadc County Product Control Section that this product or
material fails to meet the requirements of the applicab e building code.

This product is approved as described herein, and has been designed to comply with the High Velocity Hurricane
Zone of the Florida Building Code.
~SCRIPTION: “HPMA / Performance Syste 2″ Aluminum Accordion Shutter
AIpPROVAL DOCUMENT: Drawing No. ADlO-3 ,titled” System 2 Aluminum Accordion Shutter”, sheets 1
thtough lOaf 10, prepared by MCY Engineering, Inc. dated December 06, 2010, last revision # 1 dated March 27,
2d12, signed and sealed by Yiping Wang, P.E., beari the Miami-Dade County Product Control Revision stamp
with the Notice of Acceptance number and the expira .on date by the Miami-Dade County Product Control Section.
I ,
MISSILE IMPACT RATING: Large and Small Missile Impact Resistant .
LiABELING: Each unit shall bear a permanent label with the manufacturer’s name or logo, Hialeah, Florida, the
following statement: “Miami-Dade County Product C ntrol Approved”, and NOA number,per TAS-201, TAS-
2d2, and TAS-203, unless otherwise noted herein.
NEW AL of this NOA shall be considered after a enewal application has been filed and there has been no
Cinge in the applicable building code negatively aff cting the performance of this product. .
T RMINATION of this NOA will occur after the e piration date or ifthere has been a revision or change in the
m terials, use, and/or manufacture of the product or p ocess. Misuse of this NOA as an endorsement of any
p . duct, for sales, advertising or any other purposes s all automatically terminate this NOA. Failure to comply
w th any section of this NOA shall be cause for tenni ation and removal ofNOA.
I
Y.ERTISEMENT: The NOA number preceded y the words Miami-Dade County.Florida, and followed by
thl expiration date may be displayed in advertising li erature. If any portion of the NOA is displayed, then it shall
b, done in its entirety.
I SPECTION: A copy of this entire NOA shall be tOVided to the user by th.e manufacturer or its distributors
a d shall be available for inspection at the job site at e request of the Building Official.
T is NOA revises NOA # 10-1213.06 and consists 0 this page 1, evidence submitted pages E-l & E-2 as well as
aproval document mentioned above.
e submitted documentation was reviewed by ReI
MIAMI.DADE COUNTY.
NOA No. 12-0403.05
Expiration Date: 04/28/2016
Approval Date: 07/26/2012

Calleja’s Accordion Sbutters. Inc.
NOTICE OF ACCEPTANC EVIDENCE SUBMITTED
1. EVIDENCE SUBMITTED UNDER [PREVIOUS APPROVAL # 10~1213.06
A. DRAWINGS
1. Drawing No. AD10~37, titled ‘~system 2 Aluminum Accordion Shutter “, sheets 1
through 10 of 10, prepared by CY Engineering, Inc., dated December 06, 2010,
signed and sealed by Yiping Wi ng, P.E.
B.· TESTS
1. See Association’s generic approval under 10-0710.
C. CALCULATIONS
1. See Association’s generic approval under 10-0710.
D. QUALITY ASSURANCE
1. By Miami-Dade County Building and Neighborhood Compliance Department.
E. MATERIAL CERTIFICATIONS
1. See Association’s generic approval under 10-0710.
F. STATEMENTS
1. Release letter issued by the Hu ricane Protection Manufacturers Association,
dated December 13,2010, cert ing this product to meet the criteria of product
tested and approved, and allow ‘ng Calleja’s Accordion Shutters, Inc. to use the
test results approved under Mi mi Dade County Approval No. 10-0710, signed by
Mr. Henry Revilla.
2. Acknowledgment letter by Call ‘a’s Accordion Shutters, Inc. dated March II,
2011, signed by Mr. Jorge Cayon.
3. Letter by MCY Engineering, In ., dated February 05,2011, signed and sealed by
Yipping Wang, P.E., certifying hat the drawing (No. AD10-37) prepared for Calleja’s Accordion Shutters, c. is engineering wise identical to HPMA ‘s
generic drawing (No. AD10-12 .

Calleja’s Accordion Shutters. Inc.

NOTICE OF ACCEPTANCE EVIDENCE SUBMITTED

2. NEW EVIDENCE SUBMITTED
A. DRAWINGS
1. Drawing No. ADI0-37, titled ‘r’Ystem 2 Aluminum Accordion Shutter “, sheets 1
through 10 oj 10, prepared by ‘CY Engineering, Inc., dated December 06, 2010,
last revision #1 dated March 2 2012, signed and sealed by Yiping Wang, P.E.
B. TESTS
1. See Association’s generic approval under 12-0736.
C. CALCULATIONS
1. See Association’s generic apprdval under 12-0736.
E. MATERIAL CERTIFICATIONS
1. See Association’s generic apprdval under 12-0736.
D. QUALITY ASSURANCE
1. By Miami-Dade County Department oj Regulatory and Economic Resources.
F. STATEMENTS
1. Release letter issued by the Hut. icane protecti.on Manufacturers Association,
dated March 29,2012, certifyin ~hiSproduct to meet the criteria of product
tested and approved, and allow ng Calleja’s Accordion Shutters, Inc. to use the
test results approved under Mi i Dade County Approval No. 12-0736, signed
by Mr. Henry Revilla.
2. Acknowledgment letter by Call ‘a’s Accordion Shutters, Inc. dated March 29,
2012, signed by Mr. Jorge Cay n.
3. Letter by MCY Engineering, In ., dated March 29,2012, signed and sealed by
Yipping Wang, P.E., certifying hat the drawing (No. ADI0-37) prepared for
Calleja’s Accordion Shutters, L c. is engineering wise identical to HPMA ‘s
generic drawing (No. AD10-12) .
NOA ALUMINUM ACCORDION SHUTTERS-4

NOA ALUMINUM ACCORDION SHUTTERS-5

NOA ALUMINUM ACCORDION SHUTTERS-6 NOA ALUMINUM ACCORDION SHUTTERS-7 NOA ALUMINUM ACCORDION SHUTTERS-8 NOA ALUMINUM ACCORDION SHUTTERS-9

NOA ALUMINUM ACCORDION SHUTTERS-10 NOA ALUMINUM ACCORDION SHUTTERS-11 NOA ALUMINUM ACCORDION SHUTTERS-13 NOA ALUMINUM ACCORDION SHUTTERS-12

 

 

28501 S.W. 152nd Ave #140 - HOMESTEAD, FL 33033

© Copyright 2015   -  786-539-9537 / 786-234-4436- Powered by SEOlatino.com